EMF Shielding Protective Paper Yshield SAFEBUILD K150 Multipurpose | 100dB

| SAFEBUILD® K150 EMF protective shielding cellulose fleece for multiple uses.

| Highly permeable to water vapor | 100 dB | Interior | Width 70 cm.

| Cellulose fleece that is laminated on one side with a micro-needled aluminum foil. Micropuncture with 200,000 small holes per square meter makes the material very permeable to water vapor. The microholes are so small that they do not influence the attenuation of the shielding.

| Highest protective attenuation we have ever had in a standard product: 100 dB @ 1 GHz.

| Suitable for 5G!!

| Interior application. Only suitable for loose laying if the aluminum layer is protected against mechanical damage.

| Protection against high frequency (HF) radiation, and low frequency (LF) electric fields (when grounding). Measurement from 600 MHz to 40 GHz according to ASTM D4935-10 or IEEE Std 299-2006 standards.

| This product with an electrically conductive surface has to be integrated into the functional equipotential bonding (FEB). The aluminum side must be connected to ground, using the GSX10 or GSX50 tape.

Technical characteristics

• Width: 70 cm.
• Length: by linear meters.
• Attenuation: 100 dB @ 1 GHz.
• Surface conductivity: 0.0018 Ohm (square resistance)
• SD value: 0.02 m = very high water vapor permeability
• Grammage: 150 g/m² / Thickness: 0.24 mm
• Colour: White/Silver

• Corrosion resistance: Corresponds to that of aluminum
• Materials: Cellulose pulp, aluminum, adhesive powder (OEKO-TEX® certified)

Processing

| Substrate: Absorbent and chalky substrates must be pre-treated with our primer GK5.

| Bonding the aluminum side towards the room: Technically the best solution. All strips can be easily connected afterwards with the GSX earthing tape. Also the best solution with wallpaper replacement primer so that the wallpaper can be removed again if necessary.

| Gluing the white side towards the room: Visually the nicer solution that is also easy to rework.

| Adhesive: Adhesive for heavy wallpaper on the fleece side. Cellulose adhesive does not adhere to the aluminum side, we recommend our PSA adhesive, which creates a self-adhesive surface. Our aluminum products adhere very well when installed wet and dry.

| Edge on edge or overlapping: The sheets should be glued overlapping to achieve the best shielding result. Glue the overlap with our PSA adhesive. Finally, smooth with a fine putty. Alternatively, bond as usual, but this will result in minimal losses when shielding very high frequencies.

| Contact materials: Due to the aluminum layer, a neutral pH value of pH 4-9 must be ensured for all direct contact materials during processing.

Important

​| This is a custom cut or made item. We recommend that you ensure the QUANTITY and TYPE of material carefully before placing the order!! There are no returns on CUT or MADE products (on request), only against manufacturing defects!!!